SIZE:- 210 L X 150 W X 500 mm H

HIGH STOCKING AND HIGH ILLUMINATION  900L - 200G

NORMAL STOCKING AND NORMAL ILLUMINATION 1100 L - 245G

ADDITIONAL CO2 SYSTEM IS NEEDED FOR THIS UNIT BUT NOT SUPPLIED

(ROWALITH MUST BE USED FOR THESE LEVELS)

SIZE:- 180 L X 140 W X 500 mm H

NORMAL STOCKING AND NORMAL ILLUMINATION UPTO 450 L - 100G

(ROWALITH MUST BE USED FOR THESE LEVELS)

FLUIDIZED REACTOR

( NO MEDIA SUPPLIED)

COMPLETE WITH ROWALITH MEDIA, SOLENOID VALVE, TUBING ,CO2 REGULATOR WITH HIGH & LOW PRESSURE GAUGES, INTEGRATED NON RETURN VALVE, BUBBLE COUNTER, PTFE TAPE AND 500G CO2 CANNISTER

SIZE:- 180 L X 140 W X 500 mm H

NORMAL STOCKING AND NORMAL ILLUMINATION UPTO 450 L - 100G

(ROWALITH MUST BE USED FOR THESE LEVELS)

SIZE:- 240 L X 180 W X 610 mm H

HIGH STOCKING AND HIGH ILLUMINATION  1350L - 300G

NORMAL STOCKING AND NORMAL ILLUMINATION 2000 L - 444G

ADDITIONAL CO2 SYSTEM IS NEEDED FOR THIS UNIT BUT NOT SUPPLIED

(ROWALITH MUST BE USED FOR THESE LEVELS)

SIZE:- 280 L X 220 W X 610 mm H

HIGH STOCKING AND HIGH ILLUMINATION  1900L - 425G

NORMAL STOCKING AND NORMAL ILLUMINATION 2500 L - 555G

ADDITIONAL CO2 SYSTEM IS NEEDED FOR THIS UNIT BUT NOT SUPPLIED

(ROWALITH MUST BE USED FOR THESE LEVELS)

SIZE:- 350 L X 220 W X 1150 mm H

HIGH STOCKING AND HIGH ILLUMINATION  5000L - 1111G

ADDITIONAL CO2 SYSTEM IS NEEDED FOR THIS UNIT BUT NOT SUPPLIED

(ROWALITH MUST BE USED FOR THESE LEVELS)

CO2 Set For Salt water - Calcium Reactor Comprising of:

500 GRM, (full) disposable gas cylinder.
Regulator with high preasure and low preasure gauges and secondary pin wheel control.
intergrated non return valve and bubble counter,
8 bar electric solinoid plus tubing and ptfe tape.
Phosphate remover - 100ml Rowaphos for nuisance algae.

CO2 Set For Planted Freshwater aquarium Comprising of:

600 GRM, (full) disposable gas cylinder.
Regulator with preasure gauge and secondary pin wheel control.
intergrated non return valve and bubble counter and Co2 diffuser
8 bar electric solinoid plus tubing and ptfe tape.

Regulator :- comes complete with two gauges and a pin wheel adjustment and is suitable for refillable bottles.

Converts regulators valves from disposable bottles to refillable bottles.

Disposable Co2 cylinder 500 grams

Light weight bottle Complete with Co2

( 1.5 KG Shown )

8 Bar Maximum for Co2 & Freshwater Only

The solutions for the quick increase of carbonate hardness and Calcium contents.
In the marine water aquaristic the combined addition of kH+Ca 1 and 2 in a dosing of 15-20 ml/100 l aquarium water per week is recommended.
The liquids have to be dosed separately. Please do not mix in a measuring cup. In case of a combined use of kH+Ca 1 and 2 the ion proportion will not be moved within the marine water aquarium.

kH + Ca 1:The solution for a quick increase of the carbonate hardness.
The infeed of 50ml kH + Ca 1 increases the carbonate hardness by 2°kH with 100 l water. The ideal value is abt. 10° kH. The kH-value reflects the pH-buffer volume of the water. In case of a too low kH-value, there will be the danger of a pH-drop.
kH + Ca 2:The solution for a quick increase of the Calcium contents. 10ml kH+Ca 2 contains 200 mg immediately available Calcium. The ideal Ca-content of the ocean is between 400 - 450 mg/Liter. Please add kH+Ca 2 only in connection with the same quantity of kH+Ca 1 to the aquarium.

1000 ML

The solutions for the quick increase of carbonate hardness and Calcium contents.
In the marine water aquaristic the combined addition of kH+Ca 1 and 2 in a dosing of 15-20 ml/100 l aquarium water per week is recommended.
The liquids have to be dosed separately. Please do not mix in a measuring cup. In case of a combined use of kH+Ca 1 and 2 the ion proportion will not be moved within the marine water aquarium.

kH + Ca 1:The solution for a quick increase of the carbonate hardness.
The infeed of 50ml kH + Ca 1 increases the carbonate hardness by 2°kH with 100 l water. The ideal value is abt. 10° kH. The kH-value reflects the pH-buffer volume of the water. In case of a too low kH-value, there will be the danger of a pH-drop.
kH + Ca 2:The solution for a quick increase of the Calcium contents. 10ml kH+Ca 2 contains 200 mg immediately available Calcium. The ideal Ca-content of the ocean is between 400 - 450 mg/Liter. Please add kH+Ca 2 only in connection with the same quantity of kH+Ca 1 to the aquarium.

1000 ML

Instructions for use of RowaLith C+:
This material must be washed very very thoroughly before placing inside your Deltec Fluidized Reactor, if you do not do this the reactor will run cloudy.

RowaLith-C is a natural material specially chosen to produce the highest calcium output in your Deltec Fluidized Reactor.

Set the reactor to run between 30 to 40 dKH. Measure the water from the reactor after allowing it to run for a few hours, from the output flow.

Due to the efficiency of the fluidized reactor constant top up of this material will be required.
Please ensure that the calcium levels in your aquarium do not exceed 480 to 500 mg/l.

It has long been known in a reef aquariums that the inhabitants are constantly in need of calcium to build their skeletons and shells. Administering ROWAkalk to your aquarium will enhance pH as well as binding phosphates, therefore enhancing protein skimming.  ROWAkalk is the ideal supplement mix for producing kalkwasser.

Calcium hydroxide should only be administered after the calcium hydroxide (kalkwasser) mix has cleared.  The cleared and fresher the solution, the better the results.  Mechanical stirrers are highly recommended to dose kalkwasser.

To obtain the best results, you should use DO or RO water.  Dosing should take place at the lowest point of the pH cycle.  This normally being at night approximately 5 to 6 hours after the light have been turned off.  Attention should be paid to the pH when dosing as it could rise to dangerous levels if administered to fast.

The pH of calcium hydroxide when first mixed in RO or DI water should be 12.45.  The marine aquarium environment should never have a pH exceeding 8.5 and when over dosing kalkwasser, this could be exceeded if care and attention is not paid.

Hardness granules, over 99% CaCO3 (lime), grain size approx. 4 - 6 mm. For buffering the pH-value (it raises the carbonate hardness), whilst increasing the calcium content (Ca2+).

Because of the grain size and the exellent buffering capabilities, this media is ideal for all calcium reactors, allowing good water flow within the reactor.

The addition of lime water is another method to increase the calcium in saltwater aquariums. The calcium hydroxide is dissolved in a separate tank by means of the water jet of the metering pump in the osmotic regulator(s). The lime water is then released into the aquarium in small quantities in regular intervals. The calcium dispenser is fitted between the metering pump and the infeed hose. All TUNZE Osmolator, Osmomat and osmotic regulator sets can be used. The calcium dispenser can also be installed in every water storage tank. The dispenser tank should be topped up with calcium hydroxide every one to two weeks.
The calcium dispenser and the turbo calcium reactor can be combined well with each other. An especially well set pH stability is achieved during the day as well as at night. An increase in performance can be achieved for a larger consumption.
Delivery condition: Reactor, calcium hydroxide fill, holding device and connections to Osmolator, suitable for up to approx. 500 l aquariums with stone corals

For calcium dispenser 5074 and all other cacium hydroxide reacktors with "Kalkwasser"

250 G size jar

Precision unit with fine adjustment ,for conventional refillable C02 cylinders

This unit consists of the Ph controller 7070/2 and Co2 valve set 7074.11 with the power supply unit 5012.01.The 12 volt valve is protected against corrosion and is nickel coated.

On account of the adjustable time-controlled dosing,a gentle Co2 distribution is possible,preventing overdoses.

The control station is operated on a safety extra-low voltage 12/24V

AVAILABLE ACCESSORIES

Ph Electrode Glass 7070.110

Ph Electrode Plastic 7070.100

Power Supply 5012.010

Valve Set 7074.110

Switched Socket Outlet 7075.120

Probe Cleaning Solution 7040.200

Buffer Solution pH 7 & pH 9 7040.120 (Saltwater)

Buffer Solution pH 5 & pH 7 7040.130 (Freshwater)

(NEW MODEL AVAILABLE ,SORRY NO PICTURE AS YET)

High performance, quality calcium reactors incorporating a number of great features:

• Unique water intake system using a single integral pump which acts as both a supply and recirculation pump. This allows the V2React Calcium Reactor to be easily installed in any aquarium set-up without the need for a second pump or any modifications to existing pipework.

• Integral bubble counter which enables easy, measurable dosing of CO2 to the Calcium Reactor.

• pH probe holder which accepts all standard sizes of pH probes and enables the Calcium Reactor to be used in conjunction with pH monitors or controllers for more advanced aquarium set-ups.

• CO2 pressure regulator which allows for the precise control, adjustment and dosage of CO2 to the V2React Calcium Reactor.

• Ideally used with TMC Coarse Coral Gravel (not supplied) but can also be used with other similar types of Calcium media.

12 month guarantee

CO2 pressure regulator which allows for the precise control, adjustment and dosage of CO2 to the V2React Calcium Reactor.

( For Refillable bottles )

All peristaltic pumps are self priming from 5 meters with a 10 meter pumping head

Supplied with a 2 meter power cable & Wall mounting bracket

230 v AC  3 ml / min

( These are not designed to run 24/7 and so should be put on a timer)

All peristaltic pumps are self priming from 5 meters with a 10 meter pumping head

Supplied with a 2 meter power cable & Wall mounting bracket

230 v AC  7 ml / min

( These are not designed to run 24/7 and so should be put on a timer)

All peristaltic pumps are self priming from 5 meters with a 10 meter pumping head

Supplied with a 2 meter power cable & Wall mounting bracket

230 v AC  0 /7 ml / max

Variable

( These are not designed to run 24/7 and so should be put on a timer)

All peristaltic pumps are self priming from 5 meters with a 10 meter pumping head

Supplied with a 2 meter power cable & Wall mounting bracket

230 v AC  14 ml / max

Variable

( These are not designed to run 24/7 and so should be put on a timer)

All peristaltic pumps are self priming from 5 meters with a 10 meter pumping head

Supplied with a 2 meter power cable & Wall mounting bracket

230 v AC  36 ml / min

( These are not designed to run 24/7 and so should be put on a timer)

These are very handy for tapping water from main flow pipes for Nitrate filters or Calcium reactors etc.